Knot two threads on wrong side of o fabric, How to select needle position – SINGER XL100 Quantum User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
How to select needle position
(Only works with straight stitch)
Press needle position buttons to select from
among 22 possible needle positions.
M
M
M
nn
3.E
in
uu
I.Lf
Full right
How to JH^^read Cutting Groove (How to Knot the Threads)
^ Cut threads, using thread cutting
Remove material from machine.
I groove.
^ Knot two threads on wrong side of
O fabric.
After finishing a seam, raise needle and
presser foot, and slowly pull material from
under presser foot.
Hold upper and bobbin threads together,
pull them out about 4" and cut them with
thread cutting groove located at rear of
presser foot.
Pull upper thread to wrong side of fabric,
and knot upper and bobbin threads. Cut
threads as close to knot as possible.
This technique is useful for securing
pattern stitches.
Note:
It is advisable to use automatic thread cutter at end of a seam.
Use thread cutting groove located at back of presser foot for cutting thick threads or special types of thread.
15