SINGER XL100 Quantum - Manual (Page 65)

Troubles in Embroidering
If thread breaks during embroidering:
«
%
&
V
w
_jZL
&
■ /
I (5 J± .t?]
Ji
* Use key if material is fed beyond
desired position with jj key.
1. Stop sewing machine.
2. Raise needle.
3. • In case of needle thread breakage:
Properly thread machine head again.
• In case of bobbin thread breakage:
Trim needle thread and remove embroidery frame from machine.
Properly install bobbin thread in bobbin case and attach embroidery
frame.
4. Press key to feed material backward until troubled part is
reached. Then, further feed it backward a little.
5. Lower presser foot and start sewing machine.
* After sewing, draw thread remaining at beginning of sewing to
backside of material and tie. Then, trim thread.
To re-embroider troubled pattern from start:
1. Stop sewing machine.
2. Raise needle.
3. Press key, and needle will return to sewing start point.
4. Lower presser foot and start sewing machine.
Helpful messages given on LCD window during embroidering:
X
Çf
Memory is full.
Raise needle.
Embroidery card is not installed. Turn off power
and install properly.
X
This card cannot be used.
Change it with another one.
n
^ Place embroidery frame in position on machine.
Lift presser foot lifter.
Place embroidery frame on machine.
Change to full size embroidery frame.
4
Qllllll
Delete pattern with clear key.
Lower presser foot lifter.
Change needle thread to a different color.
63