Place thread spool and spool cap onto, O spool pm, Push bobbin back to left. o – SINGER XL100 Quantum User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
£%
Place thread spool
and spool cap onto
V—,i" " 11 '• I .
TKiiiiiiiiiiiiiiiiJiiiiiiJiiiiiiiri
(1) Be sure notch on spool is i
on right side.
-
,
.
(2) Use cap to hold spool in
O spool pm.
place
oUhread®
large spool
NOTE:
Some size and style spools of
thread do not deliver thread smoothly with
horizontal spool and spool cap. In this
case use vertical auxiliary spool pin.
Bobbin
winding shaft
Place bobbin on bobbin
winding shaft.
Lead thread through one
of the holes in bobbin
from inside out.
• Press bobbin against winding regulator.
\
regulator
• Hold thread while winding and trim flush with top of bobbin.
J
Push bobbin back to left.
O
t
Bobbin thread
cutter
Take bobbin off shaft
and cut thread.
Hold thread end, depress
speed controller to wind
bobbin.
*
r
9
Place bobbin in case
Pull thread Into grodS
with thread pulling off
bobbin case and draw thread to
A.
as illustrated.
B.
rear of machine
C.
Close bobbin case cover.
NOTE:
Always use Singer 15 class bobbins!