Attaching cords, 1 select desired stitch pattern. 2 change foot, Sewing one cord – SINGER XL100 Quantum User Manual
Page 53: Sewing three cords
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Attaching Cords
1
Select desired stitch pattern.
2
Change foot.
Gathering and shirring
Place pearl cotton into center of foot and zig-zag
over it.
Secure one end of pearl cotton and pull other
end to gather.
Use same method with elastic threads to create
shirring.
' Decorative shirring
Experiment with decorative threads, like ribbon
thread or metallics.
Place cording into slots and stitch using multi
stitch zigzag.
^ Applying trims
i=> For one cord
(Manual zigzag stitch
width
1
.
0
-
2
.
0
)
Multi-stitch
zigzag stitch
O For three cords
Sewing one cord
For sewing one cord, pass cord through center
spring of cording foot, fit top end of cord in groove
on sole of cording foot, then lower cording foot.
Sew cord on material using zigzag stitching
function with zigzag width reduced (stitch width
1
.
0
-
2
.
0
).
Make fastening stitches at beginning and end of
seam by pressing reverse button.
Sewing three cords
For sewing three cords, pass cords through all
springs of cording foot and fit cord ends in groove
on sole of cording foot as in case of sewing one
cord. Then, lower cording foot.
stitch pattern.
As in case of sewing one cord, make fastening
stitches, draw cords out on wrong side of material
and make a knot. Then trim cords.
* To sew two cords, pass cords through rightmost
and leftmost springs.
51