How to replace light bulb, Cleaning, Removing lint and dust – SINGER XL100 Quantum User Manual
Page 67: Caution
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
i
CAUTION:
Be sure to disconnect plug from wall outlet before opening cover.
How To Replace Light Bulb
Using exclusive screwdriver, loosen setscrews at rear and top
side of face plate cover about two turns, and pull cover straight
off.
Remove lamp cover.
Cleaning
Removing lint and dust
Accumulation of lint or dust may cause
problems. Always keep sewing machine
clean.
CAUTION:
Be sure to disconnect plug from wall outlet
before cleaning machine.
Remove needle and presser foot, and clean
area between feed dog teeth and slots in
needle plate, using brush furnished with
machine.
Always keep area around hook and bobbin
case clean.
Remove bulb by pushing bulb
upward and turn to left.
Replace by pushing upward
and turn to right.
CAUTION:
Contact dealer for correct light
bulb replacement.
Power consumption of bulb is
5 watts.
How to Replace Needle Threader Hook Holder (Optional Part) pan N0.233075
CAUTION:
Be sure to disconnect plug from wall outlet before removing needle.
Remove needle and
1
presser foot.
Push threading lever halfway
down.
Place exclusive screw
driver on top of hook
2
holder and push down.
Align slit in new hook
holder with needle
3
threader shaft pin.
Push new hook holder up
from bottom with finger
4
until it snaps in place.
65