ADLINK PCI-8134A - Manual (Page 151)

Connection Example
• 137
CN
IF
-(
3)
IOIF-(1)
IOIF-(2)
IOIF-(3)
IOIF-(4)
CN
IF
-(
2
)
8.4
Wiring with DIN-814P
Warning
The DIN-814M is used for wiring between the Panasonic MINAS MSD
series servo driver and ADLINK PCI-8134/PCI-8134A, PCI-8164
motion controller cards
To stepping
driver
4 th Axis
To Panasonic
Driver - CN1
LED indecater
GND
+24V
CN
1 CNIF-(4)
3rd Axis
To Panasonic
Driver - CN1
To
PCI-8134/8164
2nd Axis To
Panasonic
Driver - CN1
1st Axis
To Panasonic
Driver - CN1
CNIF-(1)
Mechanical I/O
Interface
-(1) : for 1st axis
-(2) : for 2nd axis
-(3) : for 3rd axis
-(4) : for 4th axis
Note:
1. The DIN-814P provides 2 connection methods for every axis. The first
is through the CNIF connector for the Panasonic MINAS MSD series
servo driver. The second is through SJ connector for stepping drivers
or other servo drivers (for the Mitsubishi J2S driver, please use DIN-
814M). Keep in mind that the signals in SJ and CNIF of the same axis
are directly shorted. DO NOT use both connectors at the same time.
2. A one-to-one 36-PIN cable is required to connect between the CNIF
and the Panasonic MINAS MSD driver. It is available from ADLINK, or
users may contact a local dealer or distributor to get cable information.