Doremi ShowVault / IMB - Manual (Page 8)

____________________________________________________________________________________
SHV.OM.001293.DRM Page 8 of 146 Version 1.5
Doremi Labs
If water or any other liquid is spilled into or onto the ShowVault, disconnect the power and call a
Doremi dealer. The unit must be well ventilated and away from direct sunlight. To avoid damage
to internal circuitry, as well as the external finish, keep the ShowVault away from direct sources
of heat (heater vents, stoves, radiators). Avoid using flammable aerosols near the ShowVault.
They can damage the surface area and may ignite. Do not use denatured alcohol, paint thinner,
or similar chemicals to clean the ShowVault. This can damage the unit.
Modification of this equipment is dangerous and can result in the functions of the ShowVault
being impaired. Never attempt to modify the equipment in any way. In order to ensure optimum
performance of the ShowVault, select the setup location carefully and make sure the equipment
is used properly. Avoid setting up the ShowVault in the following locations:

In a humid or dusty environment.

In a room with poor ventilation.

On a surface which is not level.

Inside a moving vehicle where it will be subject to vibration.

In an extremely hot or cold environment.
Removable Drives Warning
Removal of the hot swappable hard drives allows access to pins and traces supplying power to
the hard drive backplane. This is considered an energy hazard. Removal of the hard drives
must be performed by a trained service specialist or by trained personnel. The equipment may
only be used in a restricted access area which is not accessible to the general public.
Caution

Battery is located on the motherboard.

Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type recommended by the manufacturer.
 Dispose of used batteries according to the manufacturer’s instructions.