Doremi ShowVault / IMB - Manual (Page 93)

____________________________________________________________________________________
SHV.OM.001293.DRM Page 93 of 146 Version 1.5
Doremi Labs
11 Troubleshooting
11.1 ShowVault BIOS Settings
In case the system does not complete the boot sequence upon powering up, the BIOS settings
may have to be checked. Follow the procedure below to confirm the BIOS settings.
11.1.1 BIOS Setting for SuperMicro X7SBE Motherboard
Note: The BIOS settings detailed here are for units fitted with the SuperMicro X7BE
motherboard only. Check the motherboard I/Os on the rear panel to know which
motherboard is used on the unit.

To access the BIOS settings of the ShowVault fitted with the SuperMicro X7SBE
motherboard, press the DELETE key after powering on the unit when the SuperMicro
load (splash) screen appears to enter the BIOS configuration.

In the Main tab, the time and date should be set to GMT (Greenwich Mean Time).

Check that the following are active:
Native Mode Operation [Serial ATA]
SATA RAID Enable [Disabled]
SATA AHCI Enable [Enabled]
SATA AHCI Legacy Enable [Disabled]

Go to the Advanced menu and choose Boot Features. Check to see if the configuration
matches the format below:
Only USB Port #6 cab boot [Enabled]
Power Loss Control [Last State]

While in the Advanced menu, go to Hardware Monitor. Check to see if the configuration
matches the format below:
Fan Speed Control Mode [3-pin Server]

In the Boot menu, press the 3 key to load the Doremi boot order.

It will read:
Boot Priority Order:
1. USB HDD: xxxxName_of_the_Boot_Compact_Flashxxxxx

After Boot Priority is correctly set, press F10 and confirm by pressing Enter.

The ShowVault will now continue the boot process with the new BIOS settings.