Paxton Superchargers Ford Mustang GT - Manual (Page 25)

P/N: 4809654 v5.0
©2010 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
5
A. Locate the factory oil sensor on the driver’s
side of the vehicle near the oil filter.
B. Remove the sending unit and set aside.
C. Locate the supplied 1/4"NPT street TEE fitting.
Install the TEE in the same location as the fac-
tory sending unit with the 1/4" x –4 x 90°
installed in the TEE at the location noted. (See
Fig. 2-a.)
D. Attach the stainless steel –4 hose to the –4 fit-
ting installed in the street TEE. (See Fig. 2-a.)
E. Route the hose away from hot, sharp or moving
parts and to the top of the engine to be attached
to the supercharger oil feed.
*** NOTE ***
The oil feed hose to the S/C will be installed in a later
step of the installation. Temporarily cap the open end
of the hose to prevent contamination to the inside of
the hose.
F. Reinstall the factory sensor in the branch of the
TEE as shown. (See Fig. 2-a.)
2. oiL FEED iNSTALLATioN
Fig. 2-a
FACTORY
PRESSURE
SENSOR
1/4"NPT
x
-4 90°
(ENGiNE oiL-FED kiTS oNLy. Applications
with “SL” kits ignore Sections 2 & 3 and skip
ahead to Step 4.)
Section 1
PREPARATION/REMOVAL