Paxton Superchargers Ford Mustang GT User Manual
Page 82
P/N: 4809654 v5.0
©2010 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
62
Fig. 14-a
14. REFLASH CoMPUTER
D. The Reflash tool should power up and display
three parameters.
1. Performance Tune
2. Diagnostics
3. Options
E. Select “Performance Tune” and press the enter
button in the middle of the arrow keys. (See
Fig 14-c.)
IMPORTANT! To ensure trouble-free programming of your vehicle's computer:
• Make sure the vehicle's battery is sufficiently charged.
• Turn off all accessories and close doors to prevent unnecessary drain on the battery.
• Do not attempt to program your vehicle while a battery charger is connected.
• Improper battery voltage will result in failure of the programming process.
• Do not disconnect the cable or turn off the ignition during programming.
A. Reconnect the battery.
B. Locate the vehicles OBD2 connector located in
the lower left hand corner of the dash on the
drivers side of the vehicle. (See Fig 14-a.)
C. Attach the OBD2 connector from the Flash tool
that is provided in the kit to the vehicle’s OBD2
port. (See Fig 14-b.) Make sure this connector
is seated all the way in the vehicles OBD2 port.
You do not want this connector coming out dur-
ing programming or damage may occur to the
vehicle’s ECM.
F. Read the disclaimer entirely, then select agree
and press enter.
G. At this point please read the screen displayed
on the reflash tool. If you have any questions,
either refer to the manual that is provided with
the reflash tool or contact our service depart-
ment for further assistance.
Fig. 14-c
ESCAPE
ENTER
OR
SELECT
ARROWKEYS
Section 9
AIR DISCHARGE ASSEMBLY INSTALLATION
(NON-COOLED KITS ONLY)