Paxton Superchargers Ford Mustang GT User Manual
Page 66
P/N: 4809654 v5.0
©2010 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
46
Fig. 8L-i
Fig. 8L-h
Fig. 8L-j
TRIM FAN SHROUD AS
NEEDED
FOR HOSE CLEARANCE
9. Modify the small hose removed from the
factory coolant overflow reservoir. By
cutting the "S” bend off the hose end.
(See Fig. 8L-h.)
10. Install a 3/8" union and a #17 stepless
clamp. Secure the clamp. Using a length
of 3/8" (approximately 40" long) hose that
is provided, secure the hose to the union
with a #17 stepless clamp. (See Fig.
8L-i.)
11. Route the overflow hose across the radia-
tor and under the radiator retaining brack-
et to the 1/4"NPT x 3/8" hose barb fitting
in the coolant reservoir securing with a
clamp. (See Fig. 8L-j.)
8L. ENGiNE CooLANT RESERvoiR
iNSTALLATioN (2007-2010 Model H.o.
kits only), cont’d
8M. BUMPER CovER AND SPLASH PAN
MoDiFiCATioN (2010 Model H.o. kits only)
1. It will be necessary to trim the factory bumper
cover to fit the charge air cooler and piping.
Beginning with the grill you will need to trim
approximately 5" x 3 1/2" as shown. You will
also need to trim out the vertical supports in the
front (See fig 8M-a).
Fig. 8M-a
5"
3 1/2"
***NOTE***
Make small cuts in multiple steps and test fit the parts back onto
the vehicle. This will ensure proper fit and minimal material
removal.