Paxton Superchargers Ford Mustang GT User Manual
Page 63
P/N: 4809654 v5.0
©2010 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
43
8k.
ENGiNE CooLANT RESERvoiR
iNSTALLATioN
(2005-2006 Model H.o. kits only),
cont’d
Fig. 8K-i
Fig. 8K-j
9. Reinstall the factory passenger’s side
upper radiator hose removed in a previous
step. (See Fig. 8K-j.)
10. Modify the small hose removed from the
factory coolant overflow reservoir. By cut-
ting the “S” bend off the hose end. (See
Fig. 8K-h.)
11. Install a 3/8" union and a #17 stepless
clamp. Secure the clamp. Using a length of
3/8" (approximately 30" long) hose that is
provided, secure the hose to the union with
a #17 stepless clamp. (See Fig. 8K-i.)
12. Route the overflow hose across the radia-
tor and under the radiator retaining bracket
to the 1/4"NPT x 3/8" hose barb fitting in
the coolant reservoir securing with a
clamp. (See Fig. 8K-j.)
13. Check to see that all hose connections are
secure.
14. Refill the coolant system using the factory
coolant (if in good condition). Use the fac-
tory radiator cap saved during a previous
step.
15. Once the cooling system is filled and all
trapped air expelled, install the 1/8"NPT
plug provided in the previously installed
cross-over tube. Thread sealant should be
used.
Fig. 8K-h
TRIM FAN
SHROUD
AS NEEDED FOR
HOSE
CLEARANCE
FACTORY
COOLANT HOSE