Paxton Superchargers Ford Mustang GT - Manual (Page 43)

P/N: 4809654 v5.0
©2010 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
23
*** NOTE ***
For non-cooled kits skip this section and proceed to
Section 9.
8A. BUMPER CovER AND SPLASH PAN (H.o.
kits only)
1. Raise the vehicle with a floor jack and set
on jack stands.
2. Remove the seven 5.5mm headed screws
retaining the lower splash panel. (See Fig.
8A-a.)
3. Remove the six Phillips-head screws (3
each side) on the lower portions of the
plastic inner fender liners. (See Fig. 8A-b.)
4. Remove the five plastic clips retaining the
front portion of the fender liner. Both sides
need to be removed. (See Fig. 8A-c.)
5. Remove the four 10mm nuts (2 each side)
retaining the bumper cover to the fenders.
(See Fig. 8A-d.)
Fig. 8A-a
Fig. 8A-b
Fig. 8A-c
Fig. 8A-d
10mm HEADED
BOLTS
PHILLIPS-
HEAD
SCREWS
SPLASH
PANELS
Section 1
PREPARATION/REMOVAL