Paxton Superchargers Ford Mustang GT - Manual (Page 70)

P/N: 4809654 v5.0
©2010 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
50
A. Reinstall the factory passenger’s side upper
radiator hose removed in a previous step.
B. Reinstall the factory coolant reservoir using
factory hardware to secure.
C. Reattach the large hose at the bottom of the res-
ervoir to the thermostat housing using the facto-
ry hose clamp.
D. Reconnect the small overflow hose at the top
using the factory clamps.
E. Check all cooling system hose connections to
make sure they are secured with the appropriate
hose clamps.
F. Refill the cooling system using the previously
drained coolant.
F. Once the cooling system is filled and all
trapped air expelled, install the 1/8"NPT plug
provided in the previously installed cross-over
tube. Thread sealant should be used.
10. CooLANT RESERvoiR
RE-iNSTALLATioN (Non-cooled kits only)
Section 9
AIR DISCHARGE ASSEMBLY INSTALLATION
(NON-COOLED KITS ONLY)