Paxton Superchargers Ford Mustang GT - Manual (Page 35)

P/N: 4809654 v5.0
©2010 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
15
K. Locate the 4FU114-030 water pipe assembly.
L. Cut approximately 2.25" off the short 90° end
of the factory radiator hose and set aside.
(See Fig. 5.2-l.)
M. Cut the remainder of the short 90° bend from
the factory radiator hose, approximately half
way between the 90° bend and the 45° bend,
and discard. (See Fig. 5.2-l.)
N. Using the 2.25" section of radiator hose cut
previously and two #24 hose clamps provided,
install the short end of the 90° stainless tube
(4FU014-060) onto the repositioned thermo-
stat housing. (See Fig. 5.2-n.)
O. Install the remainder of the factory radiator
hose using one factory hose clamp and one
#24 hose clamp. (See Fig. 5.2-o.)
5.2 THERMoSTAT HoUSiNG/RADiAToR
HoSE MoDiFiCATioN (2007-2010
Model year only), cont’d
Fig. 5.2-l
END CONNECTED TO
RADIATOR
CUT APPROX.
2.25" AND SET
ASIDE
90° BEND TO BE
DISCARDED
Fig. 5.2-n
90° STAINLESS
TUBE (4FU014-
060)
2.25" SECTION OF
HOSE
PREVIOUSLY
TRIMMED
#24 HOSE CLAMPS
Fig. 5.2-o
FACTORY
RADIATOR
HOSE
END OF HOSE
PREVIOUSLY
TRIMMED
#24 HOSE
CLAMP
FACTORY HOSE
CLAMP