Paxton Superchargers Ford Mustang GT - Manual (Page 49)

P/N: 4809654 v5.0
©2010 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
29
Fig. 8D-a
8D. CoMPRESSoR ByPASS vALvE #2
ASSEMBLy iNSTALLATioN (2005-2006
Model H.o. kits only)
1. Cut a piece of the supplied 1" heater hose
4.5" long and a piece 15" long.
2. Attach the 4.5" piece of hose to the inlet of
the by-pass valve, securing it with a #16
hose clamp.
4.5" x Ø1" HOSE
(TRIM TO FIT)
TO DISCHARGE
TUBE AT THE
THROTTLE BODY
15" x Ø1" HOSE
(TRIM TO FIT)
TO MANIFOLD PRESSURE/VACUUM
#16 HOSE CLAMPS
TO INLET
DUCT
BYPASS VALVE
3. Secure the 15" piece to the by-pass valve
discharge using a #16 hose clamp.
4. Attach the open end of the 4.5" hose to the
by-pass port on the cast discharge duct and
secure using a #16 hose clamp. The open
end of the 15" long hose will be attached
to the inlet duct in a later step. (See Fig.
8D-a, 8D-c.)