Paxton Superchargers Ford Mustang GT - Manual (Page 56)

P/N: 4809654 v5.0
©2010 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
36
8H. CoMPRESSoR ByPASS vALvE #1
iNSTALLATioN (2007-2010 Model H.o. kits
only)
1. Cut a piece of the provided 1" heater hose
approximately 4.25" long and secure it to
the by-pass valve inlet (opposite the vacu-
um port) using the #16 hose clamps pro-
vided.
2. Locate the 1" molded rubber 45° elbow
and cut approximately 6" from the long
end and 1" from the short end. Attach the
long end to the by-pass valve discharge
and secure using the #16 hose clamps pro-
vided. (See Fig. 8H-a, 8I-a.)
3. Attach the open end of the 4.25" long hose
to the by-pass port on tube “A” and secure
using a #16 hose clamp. The open end of
the 45° hose will be connected to the inlet
duct in a later step. (See Fig. 8H-a, 8I-a.)
Fig. 8H-a
APPROX.
4.50"
MOLDED 45 ° HOSE
(7U133-045)
4.25" LENGTH
OF HOSE
TO 45 ° RUBBER HOSE
BY-PASS VALVE