Paxton Superchargers Ford Mustang GT - Manual (Page 32)

P/N: 4809654 v5.0
©2010 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
12
Fig. 5.1-e
Fig. 5.1-f
G. Locate the supplied 1-1/4" expansion plug
(7P125-002.)
H. Coat the expansion plug with sealant. Using a
tube or socket that matches the recessed diame-
ter of the plug, install the plug flush with the
machined surface sealing the outlet of the cross-
over tube. (See Figs. 5.1-e, 5.1-f.)
I. Locate the supplied coolant relocation fitting,
sealing nut and O-ring washer. (See Fig. 5 .1 -g.)
J. Install the fitting in the location of the factory
coolant bleed plug. (See Fig. 5 .1 -h.) Screw the
jam nut all the way onto the fitting. Tighten the
fitting in the position shown. (See Fig. 5 .1 -h.)
Secure with the jam nut.
*** NOTE ***
It is recommended that sealant be used to seal the
thread of the fitting.
K. Reinstall the factory O-ring gaskets to the
crossover tube.
L. Set the coolant crossover tube back in its origi-
nal location.
M. Reinstall the two 10mm headed bolts through
the cross-over tube into the cylinder heads.
Temporarily install two intake manifold retain-
ing bolts through the cross-over tube into the
cylinder heads, where the manifold will be
secured. Leave these loose as they are there
only as a pilot for the cross-over tube.
Fig. 5.1-h
Fig. 5.1-g
FACTORY
COOLANT
BLEED LOCATION
REMOVE:
NOT
REUSED
RETAIN 90°
FITTING
5.1 CooLANT TUBE RELoCATioN, (2005-
2006 only)
cont’d