Paxton Superchargers Ford Mustang GT - Manual (Page 57)

P/N: 4809654 v5.0
©2010 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
37
Fig. 8I-a
8i. CoMPRESSoR ByPASS vALvE #2
iNSTALLATioN (2007-2010 Model H.o. kits
only)
1. Cut a piece of the supplied 1" heater hose
9.5" long and a piece 14.5" long.
2. Attach the 9.5" piece of hose to the inlet of
the by-pass valve, securing it with a #16
hose clamp.
#16 HOSE CLAMPS ON
ALL HOSE ENDS
TO INLET
DUCT
14.5” X 01” HOSE (TRIM TO FIT)
(TRIM TO FIT)
9.5 x 01" HOSE (TRIM TO FIT)
TO DISCHARGE TUBE AT THE
THROTTLE BODY .
TO MANIFOLD
PRESSURE/VACUUM
BYPASS VALVE
3. Secure the 14.5" piece to the by-pass valve
discharge using a #16 hose clamp.
4. Attach the open end of the 9.5" hose to the
by-pass port on the cast discharge duct and
secure using a #16 hose clamp. The open
end of the 14.5" long hose will be attached
to the inlet duct in a later step. (See Fig.
8Ia, 8I-b.)