AMETEK ReFlex - Manual (Page 211)

DC Power Supplies ReFlex Power™
6-8 M380056-01 Rev K
V OLTAGE T EMPERATURE D RIFT
0.01% of full-scale/°C, maximum
V OLTAGE S TABILITY
0.05% of full-scale after 24 hours at constant line, load, and temperature
1.0% of full-scale after 2000 hours at constant line, load, and temperature
V OLTAGE L OAD R EGULATION
RFP-D1016-021-XXXX, RFP-D1065-5A1-XXXX:
less than 0.01% of full-scale plus 10 mV for 100% load change
RFP-D2033-030-XXXX, RFP-D2050-020-XXXX, RFP-D2050-025-XXXX,
RFP-D2120-8A3-XXXX, RFP-D2450-2A3-XXXX:
less than 0.03% of full-scale plus 10 mV for 100% load change
V OLTAGE L INE R EGULATION
RFP-D1016-021-XXXX, RFP-D1065-5A1-XXXX:
less than 0.01% of full-scale plus 10 mV for a 10% line change
RFP-D2033-030-XXXX, RFP-D2050-020-XXXX, RFP-D2050-025-XXXX,
RFP-D2120-8A3-XXXX, RFP-D2450-2A3-XXXX:
less than 0.03% of full-scale plus 10 mV for a 10% line change
V OLTAGE L OAD TRANSIENT
Less than 5% of full-scale excursion returning to the steady-state value, within
0.5% of full-scale, in 2 ms maximum, and within DC regulation limits after 10
ms for 10, 50, and 90% load step above and below 50% load.
V OLTAGE L INE TRANSIENT
Less than 1% of full-scale excursion returning to steady-state value, within
0.1% of full-scale, in 0.5ms maximum for 10% line change
R EMOTE S ENSE C APABILITY
• Remote sense compensates for at least 1.5V per load line connection.
• Maximum output power rating is valid at module output terminals,
since line drop subtracts from maximum load voltage.
•
Neither the module nor the load would be damaged by opening the
sense leads during operation; module will continue to maintain output,
but with reduced programming accuracy to 5%, maximum.
• Misconnection of the sense leads would not result in an output voltage
in excess of the over-voltage protection limit.
• Output Shutdown would occur if any of the following happen:
• Sense leads connected with reversed polarity
• Sense leads short-circuited
•
Excessive load line voltage drop