Wavetronix SmartSensor HD (101-0415) - User Guide User Manual
Page 52
Advertising
CHAPTER 5 • SETTINGS
51
Note
If you are using a SmartSensor HD in an RTMS-based system, there are two ways
to collect data from the sensor. If your system is set up to poll the sensor, the RTMS
protocol must be turned on so the sensor can respond to RTMS commands. If your
system is simply listening for data pushes from the sensor, the RTMS protocol does
not need to be turned on. See Chapter 7 for more information on data push.
Advertising