Wavetronix SmartSensor HD (101-0415) - User Guide User Manual

Page 65

Advertising
background image

64

CHAPTER 6 LANES

˽

Speed – Raises or lowers the speed calculated for all vehicles in each lane. The sensor

calculates the speed, and then multiplies the speed by this factor. The default is 100%.

˽

Length – Increases or decreases the length for all vehicles in each lane. The sensor

calculates the length and then adds the length factor. The default is 0 (feet or meters

depending on sensor units used). Since the occupancy metric that is reported in the

interval data is calculated using length, a change in the length tuning parameter will

also change the occupancy that is reported. See page 69 for the equation that is used to

calculate occupancy and for a more detailed explanation.

˽

Extension Time – Changes the extension time, which the sensor uses to prevent ve-

hicles with trailers from being broken into multiple detections. A longer extension time

will prevent this, but can lead to multiple vehicles being merged into a single detection.

The sensor automatically determines the extension time and then multiplies by this

factor. The default value is 100%.

Note

There must be a minimum of 5.5 ft (1.68 m) between vehicles in order for them to be
detected as separate vehicles. This separation requirement may increase as vehicle
speeds increase.

˽

Direction Protection – Allows you to turn Direction Protection on or off. When Di-

rection Protection is on (default), data will be shown only for vehicles that are going

in the direction set for that lane. For example, if a lane is set for traffic moving north,

any traffic in that lane that may be moving south will be ignored. However, if the sen-

sor determines that most vehicles are going a direction different from the one that was

configured (e.g. during hurricane evacuation), the sensor will begin reporting vehicles

going all directions. Turning off Direction Protection allows SSMHD to always report

data from vehicles going both directions.

Note

If a lane has been configured to be bidirectional, Direction Protection will be disabled.

Advertising