Enterasys Networks CSX6000 User Manual
Page 189
Central Site Remote Access Switch 189
C
ONFIGURING
D
EVICE
L
EVEL
D
ATABASES
On-node Device Entries
If your device requires an IP address, enter it now. Options are:
•
none
for Direct Host or WAN links that plan to use dynamic address allocation
•
0.0.0.0
for unnumbered WAN links
•
IP address #
for traditional numbered WAN links
Enable or disable IP routing for this device.
If you want dial-out capabilities to this device, enable Make calls for IP data.
If you want to apply a predefined forwarding filter to this device, specify the filter name here.
Refer to
for more information.
11. To enter any needed IPX information for your device, select IPX from the Device Table Menu.
The following screen will be displayed:
a.
Enable or disable IPX routing.
b.
If you enable IPX routing and want dial-out capabilities to this device, enable the Make Calls
feature.
c.
If you enable IPX routing, you may enable or disable IPXWAN protocol.
d. If you enable IPX routing, select IPX Routing Protocol. Select a routing protocol of none, RIP/
SAP, or Triggered RIP/SAP. When you select Triggered RIP/SAP, you will need to identify
the WAN peer type as either active or passive.
e.
If you plan to use IPX over Frame Relay, and if you are also using a CSX200 or CSX400 on
the other side of the Frame Relay connection, select IPX External WAN Net Num. Provide a
unique number that you will also reflect on the CSX200 or CSX400 platform.
f.
You may also select Spoofing Options. Make changes to default spoofing setup, if desired.
Refer to
and
for more information.
12. To enter any needed AppleTalk information for your device, select AppleTalk from the Device
Table Menu. The following screen will be displayed:
a.
Press 1 at the above menu, then follow the on-screen instructions to enable AppleTalk
routing for the device.
Device IPX Menu: (device = "DAN")
1) IPX Routing DISABLED
2) Make calls for IPX data DISABLED
3) IPXWAN Protocol DISABLED
4) IPX Routing Protocol NONE
5) IPX External WAN NetNum NONE
6) Spoofing Options
Select function from above or <RET> for previous menu:
Device AppleTalk Menu: (device = “DAN”)
1) AppleTalk Routing DISABLED
2) AppleTalk Address None
3) Make calls for AppleTalk data DISABLED
4) AppleTalk Routing Protocol None
Select function from above or <RET> for previous menu: 1