Enterasys Networks CSX6000 - Manual (Page 603)

Central Site Remote Access Switch 603
S YSTEM C OMMANDS
IP Routing Commands
ip rip routes
Displays information pertaining to the routing table(s) that are maintained by the IP RIP
protocol. The following example screen illustrates the output from this command. Following
the table is an explanation of the fields displayed for each route.
Destination
The route destination. This destination may be a network number, a subnet address, or a host
address.
Subnet-Mask
The mask used for the destination.
Next Hop
The IP address or interface name (for unnumbered interfaces) of the router that is the gateway
for the route.
Mtr
The cost of using this route (usually the number of hops to the destination).
[System Name]> ip rip interface
Status: Active
I/F Type: LAN
IP Address: 192.168.1.1
Subnet Mask: 255.255.255.0
Broadcast Address: 192.168.1.255
Transmission: Version 1
Reception: Version 1 or Version 2
Query Response: Version 1
Version 2 Authentication: Password
Status: Inactive
I/F Type: WAN - UNNUMBERED
IP Address: 0.0.0.0 (left.CSX)
Subnet Mask: N/A
Broadcast Address: 255.255.255.255
Host Route Propagation: N/A
Status: Inactive
I/F Type: WAN - NUMBERED
IP Address: 192.168.3.5
Subnet Mask: 255.255.255.0
Broadcast Address: 255.255.255.255
Host Route Propagation: When host connected
[System Name]> IP RIP ROUTES
Active Routes
Destination Subnet-Mask Next Hop Mtr P 1/2 TAge
----------------------------------------------------------------------
3.2.0.0 255.255.0.0 0.0.0.0 4 A 1/1 A30
3.3.0.0 255.255.0.0 0.0.0.0 4 A 1/1 A30
192.168.5.0 255.255.255.0 0.0.0.0 0 A 1/1 SN/A
4.4.4.1 255.255.255.255 0.0.0.0 0 A 1/1 HN/A
Inactive Routes
Destination Subnet-Mask Next Hop Mtr P 1/2 TAge
----------------------------------------------------------------------
4.0.0.0 255.0.0.0 0.0.0.0 0 H 0/1 SN/A