Enterasys Networks CSX6000 - Manual (Page 608)

USER’S GUIDE
608 CyberSWITCH
This information can help you determine if additional lines and/or systems are necessary. For
example, the high water mark could be compared to the number of ISDN B channels available,
taking into consideration the elapsed time. An example output from this command follows:
isdn usage clear
Clears the B-channel high-water mark and elapsed time values. The purpose of this command
is to allow the user to reset the high-water mark to coincide with changes to the system and/
or the network or so that the user can monitor the high-water mark over desired time periods.
LAN C OMMANDS
The following commands are used to display current system LAN diagnostic information:
lan stats
Displays the current LAN packet forwarding statistics, including the number of frames
received and transmitted from LAN and WAN connections. Refer to
LAN Statistics , for a list of
available statistics and their definitions.
lan stat clear
Clears the current LAN packet forwarding statistics.
lan test
Transmits a test message onto the LAN and test for proper LAN connections. If the transmit is
successful, the following message will be displayed:
LAN port <port #> Transmit was successful
If the transmit fails, refer to the section titled LAN Connections to determine the reason for the
failure.
L OG C OMMANDS
The following commands control the report logging feature for the system’s subsystems.
log cdr display
Displays the local call detail recording report log.
log cdr erase
Erases the local call detail recording log report.
log cdr write
Writes the local CDR log to disk. The file is written to the \LOG directory. The file name is
“CDR_LOG”. The file extension is .1, .2, and so on up to .10. The file extension cycles through
the extension values with each write command, similar to the current report log file and status
log file, so that the ten most recent versions of the CDR log are available on the system disk.
[System Name]> isdn usage
number of ISDN B channels available: 6
number of ISDN B channels in use: 3
high water mark: 5
isdnBChanUsage trap threshold: 5
generation of ISDN usage traps: enabled
elapsed time: 3 days, 4 hrs, 12 min, 38 sec