Enterasys Networks CSX6000 - Manual (Page 333)

Central Site Remote Access Switch 333
C ONFIGURING IPX
IPX Static Routes
IPX S
TATIC
R
OUTES
Note: With the availability of Triggered RIP/SAP ( page 343 ), the configuration of static routes is
no longer necessary but still supported. Situations may arise in which a remote router does
not support our implementation of Triggered RIP/SAP. In this case, it would be necessary
to configure a static route to that particular router.
C ONFIGURING IPX S TATIC R OUTES
U SING CFGEDIT
1. From the IPX menu, select IPX Static Routes.
2. Select Add a static route.
3. Enter the hexadecimal destination IPX network number.
4. Enter the device name or the hexadecimal IPX node address of the next hop device. Note that
the remote device name must be present in the on-node device database if the system is
configured for device level authentication.
5. Enter the number of hops for this route.
6. Enter the number of ticks for this route.
7. Select a RIP propagation scheme from the displayed list. Note that the third option (propagate
only when the Next Hop is connected) is displayed only when the static route Next Hop is
accessed over the WAN.
8. After all static route information has been entered, a similar screen will be displayed:
9. Follow the onscreen instructions to save the configured static route information.
There are currently no IPX Static Routes configured.
Enter (1) to Add a STATIC ROUTE or press <RET> for previous menu? 1
Enter the hexadecimal Destination IPX Network Number
or <RET> to cancel? 33333333
Enter the device name or the hexadecimal IPX Node Address
of the Next Hop device or <RET> to cancel? remote1
Enter the number of hops for this route [default = 2]? 2
Enter the number of ticks for this route [default = 2]? 2
RIP Propagation Control:
1) Do Not Propagate.
2) Always Propagate.
3) Propagate only when the Next Hop is connected.
Enter a RIP Propagation Scheme from the above menu [default = 3]? 3