Enterasys Networks CSX6000 - Manual (Page 575)

Central Site Remote Access Switch 575
R EMOTE M ANAGEMENT
Carbon Copy
Note: The above graph represents the guaranteed throughput without CRC errors. The actual
throughput may be higher.
R EMOVING C ARBON C OPY
To remove Carbon Copy from your system:
1. QUIT from the CyberSWITCH.
2. At the DOS prompt, type “dropcc”.
3. Reboot your CyberSWITCH.
N ULL M ODEM C ONNECTION
To use Carbon Copy via a local NULL modem connection to make configuration changes, follow
the steps listed below:
1. Insert Disk 1 from your Installation or Upgrade disk set labeled R2.3I13 or later, and reboot.
2. Carbon Copy will now be available via a NULL modem connection to the Serial Port.
3. Once the configuration changes have been made, remove the floppy and reboot your
CyberSWITCH. Running the system with Disk 1 inserted is not recommended.
A DDING C ARBON C OPY
If you wish to restore remote management to your system, re-add Carbon Copy by following the
steps below:
1. QUIT the CyberSWITCH.
2. At the DOS prompt, type “addcc”.
3. Reboot your CyberSWITCH.
Note: Carbon Copy is a registered trademark of Microcom Systems, Incorporated.
1024Kb 2048Kb 3072Kb 4096Kb
Legend:
nnKb
nnKb
nnKb
768Kb
2560Kb
4096Kb
1384Kb
Remote Mgt (CC) or Local Console
Only Local Console
Maximum Throughput Supported
1536Kb
1152Kb