Viewing operational information, Viewing operational information 578 – Enterasys Networks CSX6000 User Manual
Page 578
USER’S GUIDE
578 CyberSWITCH
V
IEWING
O
PERATIONAL
I
NFORMATION
The following commands are used to view system operational information:
?
Displays a help screen outlining all of the commands that are available.
br stats
Displays the current system packet statistics. Refer to
, for a list of available
statistics and their definitions.
cls
Clears the administration screen.
cs
Displays the list of connected devices along with the data rate for each device. The output for
this command contains the connection time for each device along with a detailed breakdown
(per connection type) of channel usage and available data rates. If there is at least one device
connected, the display will look as follows. Note that a “more” mechanism will be used when
the number of connected devices exceeds a full screen. If there are no devices connected, the
cs
command does not produce any output.
da
Displays reports of authentication messages. Refer to the
chapter for message
definitions.
dr
Displays reports of system messages. Refer to the chapters titled
for message definitions.
ds
Displays system statistics. For details on the available system statistics refer to the
chapter.
list [file name]
Displays the indicated file.
For example, to display the Release Notes, enter the following command:
list rel_note.txt
The “more” mechanism is used to view the indicated file. To view the next section of the file,
simply press any key (except
<escape>
). The system will automatically return to the normal
[System Name]> CS
Number of Channels Data Rate (Kbps) Connect Time
Device Name Swi Ded FrR X25 Tot Swi Ded FrR X25 Tot (hr:min:sec)
---------------- ------------------ --------------------- -----------
Tokyo 1 0 0 0 1 64 0 0 0 64 00:31:39
Ann Arbor 1 1 0 0 2 64 64 0 0 128 12:22:18
New York 4 0 0 0 4 256 0 0 0 256 04:02:22