Enterasys Networks CSX6000 User Manual
Page 604
USER’S GUIDE
604 CyberSWITCH
P
The propagation flag, where
A
= Always propagate
N
= Do not propagate
H
= Propagate when Next Hop Device Connected
1/2
RIP Version 1/Version 2 visibility flags determine whether or not this route is visible when
send the route using RIP 1 or RIP 2, where
0
= Invisible
1
= Visible
T
The type of route, where
A
= Active Route, learned via RIP on a LAN interface
P
= Permanent Route, learned via RIP on a WAN interface
S
= Static Route, learned via IP Routing Table
H
= Host Route, created when an IP Host Device is connected
Age
The time since the last update was received.
ip rip send
Used to send the IP RIP update messages to a particular interface on demand. Example:
ip rip stats
Displays global RIP statistics and also statistics for each configured RIP interface. Refer to
, for a list of available statistics and their definitions.
ip route
Displays the current routing table. Each displayed field for a route entry is as follows:
Destination
IP address for the destination network or host.
Subnet-Mask
Subnet mask value for the destination network or host. A value of 255.255.255.255 indicates
that this entry is for a specific IP host.
Next Hop
IP address or device name for the next hop router that provides access to the destination
network or the host.
Metric
Hop count to the destination network or the host.
[System Name]> ip rip send 2.2.2.2
Sending IP RIP Update Message to Network 2.0.0.0