Enterasys Networks CSX6000 - Manual (Page 531)

Central Site Remote Access Switch 531
S YSTEM M ESSAGES
System Message Summary
SSB: Post 32 i960hdlc_1 FAILURE
The i960 failed its 80532 test using the first HDLC controller. The boot process should continue;
however, make note of the error message in the event of a future problem.
SSB: Post 33 i960hdlc_2 FAILURE
The i960 failed its 80532 test using the second HDLC controller. The boot process should continue;
however, make note of the error message in the event of a future problem.
SSB: Post 34 i960hdlc_3 FAILURE
The i960 failed its 80532 test using the third HDLC controller. The boot process should continue;
however, make note of the error message in the event of a future problem.
SSB: Post 35 i960hdlc_4 FAILURE
The i960 failed its 80532 test using the fourth HDLC controller. The boot process should continue;
however, make note of the error message in the event of a future problem.
SSB: Post 36 i960isdn_1 FAILURE
SSB: Post 37 i960isdn_2 FAILURE
SSB: Post 38 i960isdn_3 FAILURE
SSB: Post 39 i960isdn_4 FAILURE
The i960 failed its 2086 test using the first (second, third or fourth) D-channel controller The boot
process should continue; however, make note of the error message in the event of a future problem.
SSB: Timed out waiting for i960 to initialize for POSTSs
The i960 did not respond to an initialization request in a timely manner. This is a i960 failure. The
boot process should continue; however, make note of the error message in the event of a future
problem.
Starting Triggered RIP/SAP for <device>
This message indicates that triggered RIP/SAP has started for a device (either locally configured
or one present in the WAN peer list). Triggered RIP/SAP has been configured as a routing protocol
for this particular device.
Stream Ready rejected - MTU too small
The remote device will only accept the stream connection if the MTU is set to be > 1514. Check to
make sure that the remote device and the CyberSWITCH MTU value is set to > 1514.
[STP] A BLAN Topology Change has been detected
The system has detected a topology change in the Spanning Tree environment.
[STP] A new Root Bridge has been detected
The system has detected a new root bridge for the Spanning Tree environment.
[STP] LAN Port <port # > is now a Designated Port
The indicated LAN port has become the designated port for the attached LAN.
[STP] LAN Port <port # > is now the Root Port
The indicated LAN port has become the root port for the system.
[STP] This Bridge is now the Root Bridge
The system has become the root bridge for the Spanning Tree environment.