Enterasys Networks CSX6000 - Manual (Page 335)

Central Site Remote Access Switch 335
C ONFIGURING IPX
IPX NetWare Static Services
IPX N ET W ARE S TATIC S ERVICES
Note: With the availability of Triggered RIP/SAP ( page 343 ), the configuration of static services
is no longer necessary but still supported. Situations may arise in which a remote router
does not support our implementation of Triggered RIP/SAP. In this case, it would be
necessary to configure a static service for that particular router.
C ONFIGURING IPX N ET W ARE S TATIC S ERVICES
U SING CFGEDIT
1. Press 6 from the IPX menu to configure a NetWare static service entry.
2. Press 1 to begin the configuration of a NetWare static service entry.
3. Enter the user-defined service name.
4. Enter the hexadecimal service type.
5. Enter the hexadecimal IPX network number for this service.
6. Enter the hexadecimal IPX node number for this service.
7. Enter the hexadecimal IPX socket number for this service.
8. Enter the number of hops to this service.
9. Select the SAP propagation control. Note that the third option (propagate only when the Next
Hop is connected) is displayed only when the static route Next Hop is accessed over the WAN.
10. After all NetWare static service information has been entered, a screen similar to the following
sample screen will be displayed:
11. Press "Y" to save the static service configuration.
U SING M ANAGE M ODE C OMMANDS
ipxsvc
Displays the current IPX service data (both statically entered and "learned").
ipxsvc [add/change/delete]
Allows you to add/change/delete an IPX service.
Service Name Admin
Service Type 0x0004 File Server
Network Address 33333333:0409a0000001:0451
Number of Hops 2
SAP Propagation Propagate only when the Next Hop is connected
Are you sure you want to add the STATIC Service (Y or N) [Y]? <RET>