Enterasys Networks CSX6000 - Manual (Page 555)

Central Site Remote Access Switch 555
T RACE M ESSAGES
X.25 Trace Messages
In - X25 CONNECTION CONFIRMATION ConnId=<connection Id> Access=<access index>
RemDteAddr=<x121 address or protocol/route id>
The system has received a connect message from the network. This indicates that a new call is now
established.
In - X25 CONNECTION INDICATION ConnId=<connection Id> Access=<access index >
RemDteAddr=<x121 address or protocol/route id>
The system has received an incoming call from the network. The system will respond with a
connect or a disconnect message.
In - X25 DATA LCN <logical channel number>, <number of bytes> bytes
Data transfer.
In - X25 DCE Clear Conf LCN <logical channel number>, <number of bytes> bytes
The DCE is confirming that an SVC call has been cleared by the DTE.
In - X25 DCE Interrupt LCN <logical channel number>, <number of bytes> bytes
An interrupt packet has been received from the DCE. Flow control procedures do not apply to
interrupt packets.
In - X25 DCE Intr Conf LCN <logical channel number>, <number of bytes> bytes
The DCE is confirming that an interrupt packet has been received.
In - X25 DCE REJ LCN <logical channel number>, <number of bytes> bytes
The DCE has detected a packet sequence error.
In - X25 DCE Restart Conf LCN <logical channel number>, <number of bytes> bytes
The DCE is confirming that all virtual circuits have been reset.
In - X25 DCE RNR LCN <logical channel number>, <number of bytes> bytes
The DCE is not ready to receive packets from the DTE.
In - X25 DCE RR LCN <logical channel number>, <number of bytes> bytes
The DCE is acknowledging data packets from the DTE.
In - X25 Diagnostic LCN <logical channel number>, <number of bytes> bytes
The DCE is providing a diagnostic packet with a cause and an error code.
In - X25 DISCONNECT CONFIRMA]TION Connid=<connection Id> Access=<access index>
The system has received a disconnect confirmation message from the network. This is usually
received after a call disconnect is either initiated by the system or the network.
In - X25 DISCONNECT INDICATION ConnId=< connection Id > Access=< access index > Cause=<cause
for disconnect> Diag=<diagnostic for disconnect>
The system has received a disconnect message from the network.
In - X25 Incoming LCN <logical channel number>, <number of bytes> bytes
An SVC call has been received from the DCE.
In - X25 Reset Ind LCN <logical channel number>, <number of bytes> bytes
The DCE is resetting a virtual circuit.
In - X25 Restart Ind LCN <logical channel number>, <number of bytes> bytes
The DCE is resetting all virtual circuits.