Enterasys Networks CSX6000 - Manual (Page 456)

USER’S GUIDE
456 CyberSWITCH
2. If Remote Mac appears in Select a file server: box, then AppleTalk Routing over the WAN
connection is operational.
3. If Remote Mac IS NOT displayed, then AppleTalk Routing feature over the WAN connection
is not operational, try the following:
a. Verify that AppleTalk Routing is operational on both the local and the remote LAN.
b. Verify that the remote resources (remote Mac) can be seen when the WAN connection is
up.
c. If the remote resources can be seen when the connection is up but not when the connection
is down, there are some problems with making outbound calls. Make sure that the
information on the remote CyberSWITCH (labeled Site 2 in the example network) contains
a proper AppleTalk address, and that Make calls for AppleTalk data for the device is enabled.
d. If the remote resources can not be seen even when the connection is up, then make sure the
AppleTalk address of the remote device is valid. If the remote device is on an unnumbered
network, then AppleTalk an address of 0.0 must be configured for the remote device in the
device table. If it is on a numbered network, the AppleTalk address does not need to be
configured for the device in the device table. However, if it is configured, it must match the
AppleTalk address configured on the remote device.