Enterasys Networks CSX6000 - Manual (Page 219)

Central Site Remote Access Switch 219
C ONFIGURING O FF - NODE S ERVER I NFORMATION
TACACS Authentication Server
U SING M ANAGE M ODE C OMMANDS
tacacs
Displays the current TACACS off-node server configuration data.
tacacs change
Allows you to change the current TACACS off-node server configuration data. After entering
the
tacacs change command, you will be prompted for the configuration elements you
want to change.
TACACS A UTHENTICATION S ERVER C ONFIGURATION E LEMENTS
IP A DDRESS
The IP address in dotted decimal notation for the TACACS Server.
UDP P ORT N UMBER
The UDP port number used by the TACACS Server. The default value of 49 is almost always used.
N UMBER OF A CCESS R EQUEST R ETRIES
The number of Access Request Retries that the system will send to the TACACS Server. The initial
default value is 3. The acceptable range is from 0 to 32,767.
T IME BETWEEN A CCESS R EQUEST R ETRIES
The time between Access Request Retries sent from the system. The initial default value is 1 second.
The acceptable range is from 1 to 10,000.
TACACS PACKET FORMAT
The TACACS format for device authentication. The default format is ID code, PIN.
TACACS A UTHENTICATION S ERVER B ACKGROUND I NFORMATION
The Terminal Access Controller Access Control System (TACACS) is a database supported by the
CyberSWITCH. TACACS operates using two components: client code and server code. TACACS
server software is installed on a UNIX-based system connected to the CyberSWITCH network. The
client protocols allow the system to communicate with the TACACS server, ultimately
authenticating devices.
The following is a typical scenario if the TACACS Server is activated: with user level security, a
remote user will Telnet into a specified system port for user authentication. The system, in turn, will
send an access request to the primary TACACS Server. After the configured time interval the
system will send an access request retry if the primary server does not respond. After the
configured number of retries, the system will request authentication information from the
secondary server if one is configured. The connection will be released if neither server responds to
the access requests.
Note: For user level security, the CyberSWITCH’s default Telnet port number is 7000, not the
normal default (23).