Enterasys Networks CSX6000 - Manual (Page 242)

C
ONFIGURING
A
LTERNATE
A
CCESSES
O VERVIEW
An access defines the connection details the CyberSWITCH uses to reach the network. The default
access is ISDN access, a switched-network access. Configurable accesses are required for
dedicated
network connections , and for packet-switched network connections including X.25 and frame relay
connections . Refer to the following information for the alternate access you wish to add.
D
EDICATED
A
CCESSES
C ONFIGURING A D EDICATED A CCESS
U SING CFGEDIT
1. Select Access from the Physical Resources menu, then follow the onscreen instructions to add a
dedicated access.
2. Select the line Id of the line you will use for this access.
3. For BRI and PRI lines: select the bearer channels the access will use.
4. For V.35 or RS232 resources, select the clocking type (internal or external clocking).
5. For Internal clocking, select the access’ data rate.
6. For External clocking, enter the Data Rate in bits per second.
7. Select the line protocol. In almost all cases, select PPP. Select HDLC only if you are connecting
to a device that uses HDLC over a dedicated access.
8. Enter the device name tied to this access (optional for accesses using PPP protocol, mandatory
for accesses using HDLC protocol).
Note: Device authentication must be enabled for dedicated accesses to properly identify the
remote device and provide switched backup and overflow to that device. Remote devices
using a dedicated connection must use PPP for device authentication. Authentication
configuration is described in
Security Configuration .
U SING M ANAGE M ODE C OMMANDS
dedacc
Displays previously configured dedicated accesses.