Enterasys Networks CSX6000 - Manual (Page 400)

USER’S GUIDE
400 CyberSWITCH
U SING M ANAGE M ODE
lineprot
Displays the current default line protocol configuration.
lineprot change
Allows you to change the default line protocol configuration. For the configuration steps, refer
to the previous CFGEDIT section.
D EFAULT L INE P ROTOCOL C ONFIGURATION E LEMENTS
A CTION ON F RAME T IMEOUT
The action to be taken if no frame is received before the configured frame timeout value has
expired. The default value is to disconnect the call. The complete list of choices is as follows:
•
Disconnect
• Use HDLC Bridge Protocol
• Use IP Host Protocol (RFC 1294)
• Use PPP Protocol
F RAME T IMEOUT V ALUE
The time limit to wait to receive a packet. The default frame timeout value is 30 seconds. The
possible range is from 5 to 60 seconds.
D EFAULT L INE P ROTOCOL B ACKGROUND I NFORMATION
When a connection occurs, the system waits for a packet to arrive, and from that packet, it
determines the protocol type. After a default frame timeout value of 30 seconds, if no packet is
received, the default action on frame timeout is to disconnect the call.
It is possible to change the timeout value for waiting for responses. You may also change the action
on frame timeout. Instead of disconnecting after the frame timeout value has been reached, you can
select a default protocol for the system to use.
L OG O PTIONS
Log options allow you to direct log reports (call detail recording, system message reports, or
authentication message reports) to a specific location. Reports can be directed to a local log file, or
to a UNIX-style Syslog Server.
C ONFIGURING L OG O PTIONS
U SING CFGEDIT
1. Select Log Options from the Options menu. A menu similar to the following will be displayed: