Enterasys Networks CSX6000 User Manual
Page 270
USER’S GUIDE
270 CyberSWITCH
5.
Configure protocol filters.
a.
Select to add a protocol filter.
b.
Select a protocol definition Id.
c.
Select a distribution list.
6.
Configure packet data filters.
a.
Select to add a packet data filter.
b.
Enter the off set value.
c.
Enter the mask in hex.
d. Enter the data value in hex.
e.
Select a distribution list.
U
SING
M
ANAGE
M
ODE
COMMANDS
Manage Mode can be used to complete all of the bridge filter configuration. This section provides
you with the commands available for each bridge filter type.
Protocol Definition Commands
protdef
Displays the current protocol definition configuration data.
protdef add
Allows a protocol definition to be added to the current configuration. Refer to the Using
CFGEDIT section for required configuration elements (
). Configure any needed
protocol definitions (
).
protdef change
Allows the current protocol definition configuration to be changed.
protdef delete
Allows a protocol definition to be deleted from the current configuration.
Source MAC Filter Commands
srcfilt
Displays the current source address filter configuration data.
srcfilt add
Allows a source address filter to be added to the current configuration. Refer to the Using
CFGEDIT section for required configuration elements (
).
srcfilt change
Allows the current source address filter configuration to be changed.
srcfilt delete
Allows a source address filter to be deleted from the current configuration.