Enterasys Networks CSX6000 - Manual (Page 266)

USER’S GUIDE
266 CyberSWITCH
9. Enable Bridging.
10. Enable Make Calls for bridge data. You must have already configured the device’s phone number
(Step 6) before the system allows you to enable this feature.
Return to the Current Device Table. The system notifies you of proper configuration for your new
device, or informs you of what you are missing.
S
PANNING
T
REE
P
ROTOCOL
C ONFIGURING S PANNING T REE P ROTOCOL
U SING CFGEDIT
Note: Although the Spanning Tree Protocol is supported for Ethernet-2 adapters only; the
Spanning Tree bridge address table aging time can be set for any Ethernet adapter.
1. Select Spanning Tree from the Bridging menu.
2. If your CyberSWITCH has an Ethernet-1 adapter, enter the bridge age time. If your
CyberSWITCH has an Ethernet-2 adapter, continue with step 3.
3. To configure the Spanning Tree elements, make sure Spanning Tree Protocol is enabled. Follow
the on-screen instructions for enabling it if it is disabled.
4. Enter the LAN port priorities.
5. Enter the LAN port path costs.
6. Enter the bridge maximum age-time.
7. Enter the bridge hello time interval.
8. Enter the bridge forward delay time if this system is the root bridge.
9. Enter the bridge age time.
Device Bridging: (Device = "DAN")
1) IP (sub)network number None
2) Bridging ENABLED
3) Make Calls for bridge data None
4) IPX Network Number None
5) IPX Spoofing Options
Id of option to change or press <RET> for previous menu? 3