Enterasys Networks CSX6000 - Manual (Page 546)

USER’S GUIDE
546 CyberSWITCH
C ALL T RACE M ESSAGE S UMMARY
Access information discarded cause
Call trace message. This message is used to indicate additional details on the <cause value>
received in the “call progress” information message.
Alerting off
Informational call trace message. The alerting signal information element is off. This indicates
additional details on the <signal value> received in the “call progress” information message.
Alerting on - pattern <pattern number>
Informational call trace message. This indicates additional details on the <signal value> received in
the “call progress” information message.
Answer tone on
Informational call trace message. This message is used to indicate additional details on the <signal
value> received in the “call progress” information message.
Call has returned to the ISDN
Informational call trace message.
Call is not end-to-end ISDN
One or more of the WAN phone networks used to connect the call is not an ISDN network. The call
must be at 56 Kbps.
Call waiting tone on
Informational call trace message. It indicates additional details on the <signal value> received in
the “call progress” information message.
Custom tone on
Informational call trace message.
Delay in response at called interface
Informational call trace message.
Destination call address is non-ISDN
Informational call trace message.
Dial tone on
Informational call trace message.
Disconnect for <tone value> tone on
This message indicates that the system disconnected the outbound call. The <tone value> values
are: error tone, busy verify, confirm, busy, network congestion, or intercept. These tone values
indicate a temporary network failure. Check the outbound phone number and try again. If the
problem persists, contact your phone company.
Expensive routing tone on
Informational call trace message.