Enterasys Networks CSX6000 - Manual (Page 605)

Central Site Remote Access Switch 605
S YSTEM C OMMANDS
IPX Routing Commands
T/P (Type/Protocol)
Type
The destination type is “R” for a remote network or host, and “L” for a locally connected
network or host.
Protocol
The mechanism used to determine the route. “L” is for local, “I” is icmp, and “R” is for RIP.
TTL
Time to Live for this route entry in seconds. This entry will expire after the specified number
of seconds. A value of 999 implies that the entry will not expire.
IF
The interface Id.
Age
The age of the route in seconds.
ip route <IP address>
Displays the routing information for the indicated device. The meaning of each displayed field
for a route entry is included in the above
ip route command explanation.
ip stats
Displays the current IP related statistics. Refer to IP Statistics for definitions.
IPX R OUTING C OMMANDS
IPX routing must be enabled before these commands can be used.
The following commands are used to display IPX routing information:
ipx ipxwan clear
Clears IPXWAN statistics.
ipx ipxwan stats (device)
Displays system-level IPXWAN statistics when device name not specified:
IPXWAN Statistics
Timer Request = Timer Response =
Information Request = Information Response =
Thruput Request = Thruput Response =
Delay Request = Delay Response =
NACK Sent = NACK Received =
Bad Packets =