Yaskawa VS-616G5 Series Revision F Programming Manual - Manual (Page 124)

124 VS-616G5 Programming Manual
Section L: Operator Parameters
O2 Key Selections
If the digital operator is disconnected from the inverter, this parameter selects whether the inverter
detects this condition.
This function can only be activated when the run command comes from the digital operator.
Setting Range: 0 to 65535 Hours
Factory Default: 0 Hours
Sets the initial value for the cumulative operation time. Operation time starts accumulating from the set
value. This is very useful for preventive maintenance purposes.
Defines the operation time that accumulates in the timer.
Sets factory defaults to worldwide specifications.
After changing this setting, reinitialize the inverter in parameter A1-03. This initialization affects mar-
ket-driven parameter settings (motor-related parameters, carrier frequency, inverter rated current, etc.)
O2-06 Digital Operator Disconnection Detection Oper Detection A A A A
Setting Description
0 Detection is disabled. Operation continues (factory default).
1 Detection is enabled. When the inverter detects that the digital operator has been discon-
nected while running, the inverter coasts to stop and the error message “OPR Operator
Disconnected” is displayed on the digital operator, after it is connected again.
O2-07 Operation Time Setting Elapsed Time Set A A A A
O2-08 Cumulative Operation Time Selection Elapsed Time Run A A A A
Setting Description
0 Power-On time is the accumulated time (factory default).
The timer counts the time while the inverter power supply is turned ON as operation time.
1 Running time is the accumulated time. The timer counts the time while the inverter is running
as operation time.
O2-09 Initialization Mode Selection Init Mode Sel A A A A
Setting Description
0 Japanese specifications
1 American specifications (factory default)
2 European specifications
3 OMRON specifications