KACO blueplanet 750 - 1000 kVA - Manual (Page 51)

KACO blueplanet 1000/875/750 TL3 M1 IS OD DEX0 Page 51
Storage/Installation/Start-up
5.11.16 Updating the software for the HMI
SAFE
NOTE
Do not remove the SD card until the SAFE icon is displayed so that it will be detected by the
HMI when you reinsert it.
Update the HMI software
Perform the following steps in the indicated sequence:
" Copy the software image file (*.img) to the SD card.
" Insert the SD card into the HMI.
" Select “Setup” → “Software upgraded”.
" Select “HMI” and press “Start”.
" A dialog box is then displayed.
Confirm the message to indicate that you understand that this process cannot be undone and HMI will start
upgrading.
" Press the “Yes” button.
A dialog box for opening files is then displayed.
" Select the image file that you copied earlier.
" Press the “OK” button.
The HMI displays the progress of the upgrade. After a short period of time, the system is restarted.
NOTE
If the image file is faulty, an error message is displayed and normal operation is resumed.
Select system
C6x
HMI
Start
HMI
Select system
Yes
HMI will start upgrading and system
will reboot. Do you really want
to proceed?
HMI
Start
No
Figure 49: Software upgrade screen Figure 50: Confirm dialog box