KACO blueplanet 750 - 1000 kVA - Manual (Page 79)

KACO blueplanet 1000/875/750 TL3 M1 IS OD DEX0 Page 79
Parameters
Parameters Min Max Unit Descriptions
PV Voltage Check
Time
0 3600 sec Inverter operation mode is changed if PV output
voltage is higher than the setting value of {MPPT V
Start} during time delay of {PV Voltage Check
Time} (When {RPO Enable} is ‘1: Enable’)
RPO Enable 0 1 - 0: RPO Mode Disable
1: RPO Mode Enable
Table 10: PV Array Parameters
Inverter Parameters
Parameters Min Max Unit Descriptions
Transformer & Type 0 1054 N/A This parameter determines device specific informa-
tion such as a switch type on DC side and whether
the inverter has an internal transformer
Inverter Capacity 100 1000 kW Power Capacity of the inverter
Inverter OverCurrent
Level 0 200 % Upper limit for inverter over current fault
Current Limit 0 150 % Limit of current which produces from the inverter
Cabinet Tempera-
ture Maximum 30 70 °C Upper limit for cabinet over temperature warning
Cabinet Tempera-
ture Minimum -25 10 °C Lower limit for cabinet under temperature warning
PEBB Temperature
Unbalance Level 5 30 °C Limit of Temperature gap between PEBBs
Test Protection
Function Mode 0 1 N/A Grid voltage and frequency protection level test
mode using AC Simulator
(Only Transformer-Less model)
PEBB Temperature
Warning Level 50 150 °C Upper limit of the maximum temperature of PEBB
(warning level)
Inverter Sub
Capacity 70 999 kW Inverter capacity to support the diversification of
model
PEBB Current
Unbalance Limit 0 100 % Limit of current gap between PEBBs
Table 11: Inverter Parameters