TA Triumph-Adler FAX 925 - Manual (Page 18)

English
Chapter 1 - Introduction 10
12. Stop key: This key cancels any operation currently in progress and
turns off the Alarm indicator. After loading paper, press this key to
cancel alarm conditions after the condition has been corrected.
During programming, pressing the Stop key takes you back step-by-
step through the programming functions you have already selected.
13. Start key: Pressing the Start key initiates the operation indicated on
the display or confirms information you have entered into the
display. While the fax machine is in power save mode, press the
Start key to exit power save mode.
14. Alarm indicator: This indicator glows red and an alarm sounds
notifies you of any problem that occurs. To turn the alarm indicator
off, press the Stop key and correct the problem.
15. Plus (+) key (One Touch key 8): Each fax number you enter or
program into your fax machine can be up to 32 digits long. When a
number is longer than 32 digits, it is possible to dial this number
using combinations of One Touch keys, Auto Dial numbers or the
numeric keypad. When programming a chain dial number into a
One Touch key or Auto Dial number, press the Plus key at the end
of the first part of the number to indicate to the fax machine that this
is a chain dial number. When programming TSI/CSI and call back
numbers into your fax machine, this key is used to enter a “+”
symbol.
Note: With the ISDN option installed, chain dial numbers can be
programmed but cannot be used.