TA Triumph-Adler FAX 925 - Manual (Page 49)

English
Chapter 4 - Basic Operations 41
5. If necessary, use the Type of Original or NO X key to set the level
of contrast in your document.
6. Your documents are now ready for faxing or copying.
Sending fax to a single location
1. Load your documents.
2. Select a location. Refer to the instructions below.
3. If necessary, press the Start key to begin the transmission. Refer to
the table below to understand some of the messages you may see
during a typical fax transmission
Original Document Set RESOLUTION to
Normal office documents Standard (STD)
Documents with small type or other fine details Fine/Ex. Fine
Documents with photos or many shades of grey Photo
Original Document Set TYPE OF ORIGINAL to
Normal contrast Normal
Contrast is too light Light
Contrast is too dark Dark
To dial using Do this
A One Touch key Press the One Touch key.
An Auto Dial number
Press the Auto Dial key, then enter the 3 digit Auto Dial number on
the numeric keypad.
Numeric keypad
Dial as you would on a normal telephone. If you make a mistake,
press the
W
YES key to go back and re-enter the number.
An external telephone
Pick up the handset of your external telephone and dial the number of
the machine you wish to transmit to. If the receiving fax machine is in
automatic reception mode, you will hear a high-pitched tone. If a
person answers the phone, ask them to press the Start key on their fax
machine.