TA Triumph-Adler FAX 925 - Manual (Page 44)

English
Chapter 3 - Dial Directories 36
3. Using the numeric keypad, enter a 3 digit number (001-100) for the
Auto Dial number you want to program.
4. The display briefly shows NO=<FAX NO.>, ID=<LOCATION ID>
or a previously programmed fax number and location ID.
5. Enter the fax number. Refer to the instructions below.
6. Press the Start key.
7. Enter the Location ID. This is a descriptive title up to 15 characters
long. Refer to the instructions below.
8. The display shows G3 COMMUN. SPEED [33.6]. Press the NO X
key to adjust the speed and the W YES key to select it.
Note: If you are experiencing problems communicating with a remote
location, try lowering the FAX SPEED or turning on ECHO
PROTECTION.
9. The display shows G3 ECHO PROTECTION [OFF]. Press the NO
X key to change the setting and WYES key to select it.
To do this Use
Enter numbers Numeric keypad (press once).
Enter spaces Space One Touch key
Enter pauses
Pause key (i.e. to wait for long distance or outside
lines)
Switch from pulse to tone dialling for
part of the call
*/Tone key
Move the cursor to make corrections Press
W
YES or
X
NO keys.
To do this Use
Enter numbers Numeric keypad (press once).
Enter spaces Space One Touch key
Enter alphabetic characters
Locate the character you want on the numeric keypad. Press
that key repeatedly until the character appears.
Enter a unique character
Press the 0/Unique key repeatedly until the character you
want appears. The following characters are available: ! # & ’ (
) * + , - . / : ; = ? · д Я с ц ь Ж Е Ш ж е ш
Enter two characters using
the same key
Press the NO
X
key to move to the next character.
Move the cursor to make
corrections
Press
W
YES or
X
NO keys.