TA Triumph-Adler FAX 925 - Manual (Page 82)

English
Chapter 6 - Programming 74
Note: If you have purchased the optional MFP software and you have
connected your fax machine to a PC, it is recommended that you
turn 18:POWER SAVE MODE off. Your PC cannot switch your
fax machine back to full operation.
19:ECM FUNCTION: The error correction mode function helps your
fax machine to improve communication in areas where telephone line
conditions are poor. Available settings are ON and OFF.
Note 1: When using ECM, the transmitting fax machine automatically
checks the data as it is sent. If the receiving fax machine cannot
verify the transmission, the transmitting fax machine will
retransmit as necessary. Using ECM also increases transmission
time because the data is checked as it is transmitted.
Note 2: When you set ECM to off, maximum fax communication in G3
mode is 14,400 bps.
20:REMOTE DIAGNOSIS: The remote diagnostics feature allows a
service person to remotely dial and service your fax machine. Available
settings are on and off.
21:PC/FAX SWITCH: When your fax machine is set to answer in PC
Receive Mode and your optional MFP software is set to receive fax
messages, all incoming calls are transferred directly to your PC. However,
if you are experiencing a problem with your PC, you can tell your fax
machine to receive and print faxes locally by setting this function to on.
Available settings are on and off.
22:NO TONER MEM. RX: With this function turned on, your fax
machine automatically receives and stores messages in its memory when
toner is low. When turned off, messages print even if toner is low or
empty. Available settings are on and off.
Note: The off setting allows time for you to replace the toner cartridge,
but quality of printing may become poor as the toner cartridge is
exhausted.
23:MEM. FULL SAVE: With single location transmission and
17:MEM./FEEDER SW. set to MEM and 25:INSTANT DIALLING is
set to off, and with multiple location transmission, call origination starts
after an entire document is read into memory. If during this process
memory becomes full, a MEMORY OVERFLOW message is shown in
the display and the display changes to SEND SCANNED PAGES.