TA Triumph-Adler FAX 925 - Manual (Page 45)

English
Chapter 3 - Dial Directories 37
Note: If the ISDN option is installed, the display will show ISDN DIAL
MODE (G4). Press the
WYES key to select G4 as the dial mode
for this One Touch key or press NO
X key to change to G3 dial
mode and then press the
WYES key to select it.
10. After pressing the WYES key, the display automatically shows
LOCATION PROGRAMMING ENTER (SRCH, OT, A/D, #)
11. To continue programming AUTO DIAL numbers, go back to Step
3. If you are finished programming, press the Select Function key.
Note: If you want to delete any programming for an Auto Dial number,
follow Steps 1 - 4. At Step 5, press the 9/Space key until the
number is deleted, then press the Start key and continue with
Step 11.
Programming groups
Once you have programmed some One Touch keys or Auto Dial numbers,
you can then program these numbers into groups to allow you to send the
same fax to multiple locations. You can program up to 10 groups using a
maximum of 80 numbers for all 10 groups into your fax machine.
1. Press the Select Function key, then press the 8/Location Program
One Touch key. The display shows LOCATION PROGRAMMING
ENTER (SRCH, OT, A/D, #)
2. On the numeric keypad, press the # key. The display shows GROUP
SETTING [
] ENTER 1-10
3. Using the numeric keypad, enter the group number (1-10) you want
to program.
4. The display shows the number of your current group and SELECT
LOC.(S) YES (STR/LOC.) EXIT (X). You can now add a location
to your group (or delete a location from it). Refer to the instructions
below.
To do this Use
Add a One Touch location Press the One Touch key. Press Start to add it to the group.
Add an Auto Dial location
Press Auto Dial. Enter a 3 digit Auto Dial number. Press Start
to add it to the group.
Delete a One Touch location
Press the One Touch key. Press Start to delete it from the
group.