TA Triumph-Adler FAX 925 - Manual (Page 79)

English
Chapter 6 - Programming 71
02:MCF. (MULTI-LOC.): This function prints a general Message
Confirmation Report and a detailed Broadcast Confirmation Report after
each multiple location transmission. Available settings are on and off.
03:ERR. REPORT (MCF.): This function automatically prints a
Message Confirmation Report each time an error occurs during a
transmission or polling transmission operation. Available settings are on
and off.
04:IMAGE IN MCF.: When a Message Confirmation Report is
automatically printed, this function adds a portion of the first page your
fax machine transmitted. This is printed at the bottom of the message
confirmation report. Available settings are on and off.
Note: This image function only becomes effective if user function
17:MEM./FEEDER SW. is set to MEM and/or user function
25:INSTANT DIALLING is set to ON.
05:SENDER ID: This function controls the printing of your fax
machine’s Sender ID on the faxes you send. When turned on, your fax
machine’s Sender ID, date and time will be printed on each page slightly
outside the image area of your document. When turned off, your Sender
ID, date and time will not be printed. However, some fax machines will
print your TSI/CSI.
06:MONITOR VOLUME: This function sets the volume your fax
machine uses for telephone line monitoring sounds during dialling.
Available settings are LOW, MID, H-MID, HIGH and OFF.
07:BUZZER VOLUME: This function sets the volume of the various
beep and alarm tones your fax machine emits during operations. Available
settings are low, middle and high.
08:CLOSED NETWORK: This function allows you to program your
fax machine to refuse to receive faxes from or transmit faxes to locations
whose telephone numbers have not been programmed into your fax
machine’s One Touch keys or Auto Dial numbers. Using this function,
you can set up a closed network of fax machines. If you do not want your
fax machine to transmit faxes to or receive faxes from locations outside
your network, select T/R. If you only want your fax machine to refuse to
receive faxes from outside your network, select RX. Available settings are
OFF, T/R and RX
09:TX MODE DEFAULT: This function allows you to change your fax
machine’s default type of original, transmit and copy resolution settings.
Unless you select otherwise using the Transmit Resolution/W YES or