TA Triumph-Adler 2256 - Manual (Page 36)

2-8
Installing and Setting up the Machine > Connecting Cables
Connecting LAN Cable
1 Connect the cable to the machine.
1 Connect the LAN cable to the network interface connector.
2 Connect the other end of the cable to the hub.
2 Power on the machine and configure the network.
Connecting the Power Cable
Connect one end of the supplied power cable to the machine and the other end to a power outlet.
IMPORTANT
If the power is on, turn the power switch off.
Power Off (page 2-9)
Network Setup (page 2-15)
IMPORTANT
Only use the power cable that comes with the machine.